When you look at the back side of an SD card, there are 9 contact pins that need to fit snug against the transmitting contacts within the socket of your camera’s housing. If this does not happen, the camera will not be able to read the card, and will provide errors such as card full.įirst and foremost take a physical look at the card itself. Inspect the contact pins to make sure that there is no damage to the pins. Scratches and general wear will happen over time, especially when you are using the card frequently over a long period of time. When this happens, it is time to replace the card. The second possible problem is that there is some sort of dirt or debris inside the camera’s SD socket. This commonly happens when your camera is in areas, such as a worked farm field, where there is more dust in the air than usual. Simply take an aerosol dust cleaner and blow into the socket. You could also just use your mouth to blow, but be careful not to allow any moisture into the socket. As we know, moisture and electronics do not mix well. A simple burst of air should dislodge any dust that is preventing a connection. On every SD card there is a small switch on the side of the card that has the ability to lock the card. This switch is simply to prevent a car from being overwritten. Often times when your trail camera says that the card is locked, is due to this one simple problem. It can easily be bumped by putting your card in and out of your camera. The solution is very quite simple, just flip the switch back to unlock. Sometimes you might have to flip it back and forth a few times in order for it to work, but most times this your problem. The switch is however a cheap mechanical device, and sometimes when just simply move it back to the unlocked position doesn’t work. This is often because the switch on the inside of the card has been broken. SD Card Isn’t Collecting Photos Not Formatted Properly In this case, just simply grab a new card, it is impossible to fix in the field and not worth the headache to begin with. If your camera is taking pictures, but not transferring them to the SD card, this is a sign that the camera is reading that there is a card there, but can not place photos or videos onto the card. This is typically a sign of improper formatting.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |